home *** CD-ROM | disk | FTP | other *** search
/ Tech Arsenal 1 / Tech Arsenal (Arsenal Computer).ISO / tek-20 / mods_all.zip / TM721A.7 < prev    next >
Text File  |  1992-09-15  |  2KB  |  41 lines

  1. TM721A.10
  2. OPERATING PROCEDURES
  3.  
  4. Repeater cross-band operation allows the TM-721A to receive on one band
  5. and retransmit the signal on the other band.  An incoming signal will
  6. automatically be switched to the sub-band.  The TM-721A will then
  7. retransmit the signal from the main band.  Each band may contain offset
  8. and sub-audible information (TSU-6 is required for decode).  The encode
  9. and decode tones for a single band must be the same.  Of course, the
  10. encoder or decoder may be shut off by using the [TONE] and [CTCSS] keys.
  11. In addition, each band may contain a separate sub-audible tone.
  12.  
  13. 1.  Select the first frequency in the main band.  If required select the
  14.     offset.
  15.  
  16. 2.  Select a tone if needed.  Selecting a tone will not turn on the
  17.     encode or decode functions.  To turn on the encoder, press the TONE
  18.     key (the [T] indicator will light in the main display).
  19.  
  20. 3.  Press the BAND key to move the contents of the main display to the
  21.     sub-display.  The decoder can now be turned on by pressing the F key
  22.     and then the CTCSS key (the [CTCSS} indicator will light in the
  23.     sub-display).
  24.  
  25. 4.  Now select the second frequency in the main band.  Follow steps 1 - 3
  26.     as needed to select the offset and tone information.
  27.  
  28. 5.  Adjust the main and sub-band squelch controls to the threshold point.
  29.     The TM-721A will transmit in the repeater cross-band mode if the
  30.     squelch controls are too low or a signal is received.
  31.  
  32.         NOTE:  The next two steps place the unit in the cross-band
  33.         repeater mode.
  34.  
  35. 6.  Press the F key
  36.  
  37. 7.  Press the A.B.C key within 5 seconds of pressing the F key.  Three
  38.     dots should appear in the main and sub displays.  The unit will now
  39.     operate as described.
  40.  
  41.